Cozy Experimental Aircraft Project

The boards and 5-min epoxy blobs were removed from the bottom of the fuselage.

Taping the floor to the front seat joints (seatback & fuselage sides). Workshop temperature was 24 deg C and humidity 51%. Cut 2 layers of BID cloth to cover two 2″x17″ and two 2″x19″ strips.   Mixed 120g resign with 46g hardner to make a batch of epoxy. Wet out the BID cloth and the …

Cozy Experimental Aircraft Update – May 13, 2018 Read More »

Taping the rear seat fuselage sides to the floor:   Cut 2-ply of BID cloth to make two 2″ x 30″ and two 2″ x 13″ strips of BID tape. Workshop temperature was 25 deg C and the humidity 48%. A batch of epoxy was mixed using 124g resin and 47g hardner. The BID cloth …

Cozy Experimental Aircraft Update – May 6, 2018 Read More »

Removed the temporary board supporting the aft end of the floor then scraped the glue from the landing gear bulkhead. Shop temperature 25 deg C and humidity 41%. Cut 2 pieces of BID cloth 33″ x 2″. Mixed a cup of epoxy using 112g resin and 42g hardner. Wet out the 2-ply BID tape then …

Cozy Experimental Aircraft Update – April 15, 2018 Read More »

Permanent Installation of the aircraft floor. Shop temperature was 25 deg C and humidity 39%. Several batches of medium stiff flox was mixed.    The flox was applied on all the mating surfaces: longerons, seatback, heat duct, and front bulkhead F22. Shims were positioned and floxed. Noah helped me lift the floor off the work …

Cozy Experimental Aircraft Update – March 31, 2018 Read More »