The shoulder support braces were fit into position and temporarily held in place with nails. Next, the headrest pieces were glassed. Shop temperature 25 deg C and humidity 62%. 124g resin and 47g hardner were mixed and split into 2 cups. Glass bubbles were added to 1 cup and the headrest pieces were covered with …
Cut out the shoulder braces for the front seatback and redoing the headrests.
The front headrest pieces were cut out and assembled with 5-minute epoxy using a little flox mixed in. The right side headrest gets a front, back, and two sides whereas the left side headrest gets a front, two sides, and a bottom. The left side will be fastened to the canopy and the right side …
Crosswind circuit practice this morning at CYPQ then setting up for ground school work in the hangar. Here is a video from the flight. Contact us at [email protected] if you have any questions about learning to fly tailwheel aircraft and visit us at the Beyond Blue Shop.
This was the 2nd flight of the Conquest model rocket plane at our Crooked Creek facility. Here is a short video of the flight. The 1st launch of the Conquest can be seen here if you are interested. The purpose of this 2nd flight was to test out some new electronics and to launch the …
