I will plan to install the ILS, COMM, and GPS antennas but no marker beacons or adf antennas. Marker Beacons are generally being decommissioned everywhere. (i.e. Outer Marker (OM) / Middle Marker (MM) / Inner Marker (IM)). I will install an ILS and plan to use the GPS waypoints along the approach to know where …
Cozy Experimental Aircraft Update – January 19, 2019 Read More »
Cut a piece of birch plywood 5″ x 2″. Marked the location on the left side of the fuselage where this will be inserted. This insert is positioned 32.75″ aft of bulkhead F22 which places it abeam the front seat area. This insert will be used to support an aluminum step which is installed later. …
Cozy Experimental Aircraft Update – January 12, 2019 Read More »
Sanded a 1″ wide 1/16″ deep depression at the forward end of the fuselage where the nose will interface with the fuselage. More sanding on both fuselage sides to further round out the bottom to side transitions.
A short flight from CYPQ (Peterborough) to CNF4 (Lindsay) for lunch. The power went out in Lindsay so warm coffee and soup was the only thing available. I was happy I could still get a coffee ! Here is a short video of the flight. I found this autographed photo of Canadian Astronaut Chris Hadfield …
Vacuumed the landing brake and the fuselage where the landing brake is installed. Tacked the landing brake in place with 5 minute epoxy. Canadian Tire didn’t have 1″ wide duct tape so I cut a standard duct tape width to 1″. I built up the area 1″ wide alongside and aft of the landing brake …
Cozy Experimental Aircraft Update – January 1, 2019 Read More »
