Install Floor Spacers for Console: Workshop was heated to 25 deg C and the humidity was 31%. 96g resin was mixed with 36g hardner and glass bubbles to make a batch of micro. A small portion was poured into a 2nd mixing cup with more glass bubbles to make a small batch of dry micro. …
Cozy Experimental Aircraft Update – February 3, 2018 Read More »
Micro the aft aircraft floor spacers in place: Workshop temperature was 25 deg C and humidity 35%. 122g of resin was mixed with 46g of hardner and glass bubbles to make a batch of micro. Some of the batch was poured into a second mixing cup and more glass bubbles were added to the 2nd …
Cozy Experimental Aircraft Update – January 29, 2018 Read More »
In the circuit at CYPQ to test that the electrical and magneto snags discovered a few weeks ago have been resolved. Electrics and magnetos all worked well. Here is a short video clip of the flight. The new tailwheel socks also worked well 🙂
Please take a moment today to remember the crew of the Challenger and their families. On Jan. 28, 1986, the booster engine failed, causing the Shuttle Challenger to break apart just 73 seconds after launch. In this photo from Jan. 9, 1986, the Challenger crew takes a break during countdown training at NASA’s Kennedy Space …
Installing the centre floor spacer over the landing brake cutout. The workshop temperature was 25 deg C and the humidity was 36%. 110g resin, 42g hardner, and micro bubbles were mixed together and applied with a squeegee to the floor area where the centre spacer is installed. The centre spacer was positioned in place and …
Cozy Experimental Aircraft Update – January 26, 2018 Read More »
